MultiSegmentPipe class/Pipe Radius property

VI Server Property Information
Property ID	311C4C04
Scope	Basic Development Environment
Data Name	PipeWidth
Short Name*	PipeRadius
Long Name*	Pipe Radius
* Displayed here in English. Short and Long names appear in the language of the LabVIEW IDE.
Owning Class ID	130
Owning Class Name	MultiSegmentPipe Class
Data Type	U32 data type
Property Node
Available in Real-Time Operating System	Yes
Available in Run-Time Engine	Yes
Loads the block diagram into memory	No
Loads the front panel into memory	No
Need to authenticate before use	No
Permissions	Read/Write
Remote access allowed	Yes
Settable when the VI is running	Yes

Gets or sets the radius of the pipe segments in a pipe network. All pipe segments in a pipe network have the same radius.

The pipe radius is the distance, in pixels, between the center of a pipe segment to the edge of the pipe segment. The maximum pipe radius is one pixel less than the radius of the narrowest flange. The radius of a flange is equal to the pipe radius plus the flange width. The minimum pipe radius is five pixels. LabVIEW returns an error if you specify a pipe radius greater than the maximum or less than the minimum pipe radius.

The following illustration shows the pipe radius.

<img src="loc_fp_pipe_radius.gif"> You also can set the pipe radius interactively.

History

Version	Change(s)
	More info to come.